Grizzly G1199, G1200 instruction manual Table Adjustments

Page 14

Spindle Adjustments

 

Table Adjustments

 

 

 

 

 

 

 

 

 

 

 

 

To stop the vertical travel of the drill bit at a desired depth, loosen the scale set knob located on the feed shaft assembly, rotate the handles to the desired depth and tighten the scale set knob.

Figure 12.

To hold a stationary depth, loosen the scale set knob and rotate the feed shaft to its lowest point. Then, rotate spindle depth to the desired depth and tighten the scale set knob. This will lock the spindle at the desired depth.

scale set knob

Figure 12.

1.To adjust the table up or down, loosen the col- umn lock handle and turn the crank handle to the desired height. Re-tighten the column lock handle. Figure 13.

lock handle

Figure 13.

2.To swing the table, loosen the column lock handle and swing the table to the desired position. Re-tighten the column lock handle. For long workpieces, swing the work table away 180° and use the base as your table.

Figure 13.

3.To rotate the table, loosen the table lock han- dle, rotate the table to the desired position and re-tighten the table lock handle. Figure 14.

-12-

G1199/G1200 Drill Press

Image 14
Contents Drill Press Model G1199/G1200G1199/G1200 Drill Press Table Of Contents Introduction Safety Rules For All Tools Unpacking Piece Inventory Overview of all the parts G1199/G1200 Drill PressClean up Site Considerations Circuit Requirements Assembly Beginning Assembly Base/ColumnPage Handles installed G1199/G1200 Drill Press TableHANDLESDrill Chuck Adjustments Speed ChangeTable Adjustments Chuck Removal Removing the chuck G1199/G1200 Drill PressSafety Rules OperationsTest Run Drill Changes Drill Speed Drilling Metal Mortise Attachment installed G1199/G1200 Drill Press Drilling Wood Mortise AttachmentBelt Tension MaintenanceGeneralLubrication Closure 32A 32B 100 Base PN02M Machine Data Troubleshooting Warranty and Returns Recommended RPM B a G1199/G1200 Drill Press