Figure 14.
4.To tilt the table, loosen the pivot bolt and remove the locator pin (Figure 15). This is done by tightening the nut until the pin is extracted from its hole. Tilt the table to the desired angle (up to 45°) and
Figure 15.
Chuck Removal
1.Adjust the stationary depth to three inches (see depth setting instructions).
2.Rotate the spindle manually and line up the internal spindle slot with the slot on the side of the quill. The end of the drill chuck (the tang) should be visible through the slot at this point.
3.Insert the wedge shifter through the slot in the spindle with the tapered edge facing down.
Figure 16.
4.When the tapered edge of the wedge shifter contacts the top of the taper, tap the wedge shifter lightly with a hammer until the taper and chuck are loose. Do not allow the taper and chuck to fall onto the table.
Figure 16. Removing the chuck.
|
|
|
|
|
|
|
|
|
|
|
|
G1199/G1200 Drill Press | |||