Ryobi P231 manual Charging the Battery Pack, Charging a Cool Battery Pack

Page 10

OPERATION

LED FUNCTIONS OF CHARGER

LED WILL BE ON TO INDICATE STATUS OF CHARGER AND BATTERY PACK:

nRed LED on = Fast charging mode.

nGreen LED on = Fully charged and in maintenance charge mode.

nGreen LED on = When battery pack is inserted into charger, indicates hot battery pack or that battery pack is out of normal temperature range.

nYellow and Green LEDs on = Deeply discharged or defective battery pack.

nNo LED on = Defective charger or battery pack.

CHARGING THE BATTERY PACK

Battery packs for this tool are shipped in a low charge con- dition to prevent possible problems. Therefore, you should charge it until the green LED on the front of the charger comes on.

NOTE: Batteries will not reach full charge the first time they are charged. Allow several cycles (operation followed by recharging) for them to become fully charged.

CHARGING A COOL BATTERY PACK

If battery pack is within normal temperature range, the red LED on charger will come on.

NOTE: If the charger does not charge the battery pack under normal circumstances, return both the battery pack and charger to your nearest Ryobi Authorized Service Center for electrical check.

n Charge the battery pack only with a recommended charger.

n Make sure the power supply is normal household voltage, 120 volts, 60 Hz, AC only.

nConnect the charger to the power supply.

nPlace the battery pack in the charger aligning raised rib on the battery pack with the groove in the charger. See Figure 2.

nPress down on the battery pack to be sure contacts on the battery pack engage properly with contacts in the charger.

nNormally the red LED on charger will come on. This indicates the charger is in fast charging mode.

nRed LED should remain on for approximately 1 hour then the green LED will come on. Green LED on indicates battery pack is fully charged and charger is in maintenance charge mode.

NOTE: The green LED will remain on until the battery pack is removed from the charger or charger is disconnected from the power supply.

nIf both yellow and green LEDs come on, this indi- cates a deeply discharged or defective battery pack. Allow the battery pack to remain in the charger for 15 to 30 minutes. When the battery pack reaches normal voltage range, the red LED should come on. If the red LED does not come on after 30 minutes, this may indicate a defective battery pack and should be replaced.

nAfter normal usage, a minimum of 1 hour of charging time is required to fully recharge battery pack.

nThe battery pack will become slightly warm to the touch while charging. This is normal and does not indicate a problem.

nDo not place the charger and battery pack in an area of extreme heat or cold. They will work best at normal room temperature.

NOTE: The charger and battery pack should be placed in a location where the temperature is more than 50°F but less than 100°F.

nWhen batteries become fully charged, unplug the charger from power supply and remove the battery pack.

BATTERY PACK

CHARGER

P110

YELLOW

GREEN

RED LIGHT

LIGHT

LIGHT

 

Fig. 2

10

Image 10
Contents OPERATOR’S Manual Save this Manual for Future ReferenceTable of Contents IntroductionPersonal Safety General Safety RulesElectrical Safety Work AreaSpecific Safety Rules ServiceSafety Rules for Charger Symbols Symbol Name DESIGNATION/EXPLANATIONSymbol Signal Meaning Switch Trigger Product SpecificationsSwitch Lock Know Your Impact DriverUnpacking AssemblyOperation Packing ListCharging the Battery Pack Charging a Cool Battery PackTo Install Battery Pack Charging a HOT Battery PackTo Remove Battery Pack Reversible BUILT-IN CouplerInstalling Bits Removing BitsBattery Pack Removal Preparation for Recycling MaintenanceGeneral Maintenance BatteriesPage Service Model NO. and Serial no