OPERATION
CHARGING A HOT BATTERY PACK
When using the tool continuously, the batteries in the battery pack will become hot. You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge. When the battery pack becomes discharged and is hot, this will cause the green LED to come on instead of the red LED. After 30 minutes, reinsert the battery pack in the charger. If the green LED continues to remain on, return battery pack to your nearest Ryobi Authorized Service Center for checking or replacing.
NOTE: This situation only occurs when continuous use of the tool causes the batteries to become hot. It does not occur under normal circumstances. Refer to “CHARGING A COOL BATTERY PACK” for normal recharging of batter- ies. If the charger does not charge your battery pack under normal circumstances, return both the battery pack and charger to your nearest Ryobi Authorized Service Center for electrical check.
TO INSTALL BATTERY PACK
See Figure 3.
nLock switch trigger on the tool by placing the direction of rotation selector in center position.
nPlace battery pack in the tool. Align raised rib inside tool with groove on battery pack.
nMake sure the latches on each side of the battery pack snap into place and battery pack is secured in tool before beginning operation.
CAUTION:
When placing battery pack in the tool, be sure raised rib inside tool aligns with groove on battery pack and latches snap in place properly. Improper assembly of battery pack can cause damage to internal components.
TO REMOVE BATTERY PACK
See Figure 3.
nLock switch trigger on the tool by placing the direction of rotation selector in center position.
nLocate latches on end of battery pack and depress to release battery pack from the tool.
nRemove battery pack from the tool.
LATCHES
| BATTERY PACK | |
DEPRESS LATCHES TO | (NOT INCLUDED) | |
Fig. 3 | ||
RELEASE BATTERY PACK | ||
|
11