OPERATION
TURNING ON/OFF
See Figure 4.
Press the switch located on the right side of the laser level to turn it ON and OFF. Always wait for at least 5 seconds between stopping and restarting the laser level.
PRESS TO
TURN ON
ON/OFF | PRESS TO |
|
SWITCH |
| |
| TURN OFF | Fig. 4 |
POSITIONING THE LASER LEVEL
The laser level has several positioning options available to suit the needs of your project.
For a quick reference or alignment between two points, the laser level can be hand held or placed on a horizontal surface.
USING THE AIR-GRIP VACUUM
See Figure 5.
The laser level’s vacuum grip technology al- lows attachment to most smooth surfaces.
NOTE: The
nPlace the laser level on the surface you want it secured to and push in slightly to seal.
nContinue to hold the laser level against the surface while pressing the on/off switch.
nRelease the laser level when you hear a change in motor sound.
NOTE: To release the vacuum seal, turn the laser level’s power off. For fast release, press the protrusion on the back of the unit. Pulling the laser level off the wall without releasing the vacuum could damage the tool.
The laser will automatically shut off 15 min- utes prior to battery failure, but the motor will remain on. Press the on/off switch to power down the unit and replace the batteries.
ON/OFF |
|
SWITCH | Fig. 5 |
10