Rough Surface Adaptor, Using MULTI-FUNCTION Base

OPERATION

ROUGH SURFACE ADAPTOR

See Figure 6.

Using the rough-surface adaptor, you can use the laser level’s AIRgrip™ feature to positon the unit on many non-smooth surfaces, including brick and painted cinderblock.

NOTE: The AIRgrip™ feature cannot be used with stucco or unpainted cinderblock.

nPosition the rough-surface adaptor on the surface where you want to secure the laser level.

NOTE: The dotted lines on the adaptor should be visible.

nPlace the laser level against the adaptor on the dotted lines, and push in slightly to engage the seal.

nContinue to hold the laser level against the surface while pressing the on/off switch.

nRelease the laser level when you hear a change in motor sound.

USING MULTI-FUNCTION BASE

See Figure 7.

Velcro® strap, push pin, and tripod mounting methods are available only when the multi- function base is installed. To install the base:

nWhile holding the laser level with the power switch facing you, align the raised ridge on the base with the groove on the level.

nSlide the laser level and base completely together.

NOTE: If the base is seated correctly, the vacuum will not operate when the power is turned on.

VELCRO® STRAP: The strap can be used to attach the laser level to irregularly shaped

Fig. 6