Ryobi ELL0001 manual Troubleshooting, Problem Cause Solution

Page 16

TROUBLESHOOTING

PROBLEM	CAUSE	SOLUTION

Laser line projection is	Batteries are low.	Replace with fresh
weak.		batteries.

Laser is off, but motor is	Batteries are low.	Replace with fresh
on and vacuum is working.		batteries.

Laser line is hard to see.	Light in area is too bright.	Use in dimmer area or use
		laser-enhancing glasses.

Laser line is not level.	1. Leveling bubbles not	1. Make sure bubble on
	properly aligned.	vial is centered.
	2. Level is mounted on	2. Make sure the bubbles
	base that isn’t level.	are level after mounting
		to base.

Laser line is horizontal	Laser lens is in the	Turn the laser lens 90˚ to
when a vertical line is	incorrect position.	the vertical orientation.
desired.

16

Image 16

Contents AIRgrip Laser Level Table of Contents IntroductionSafety Rules Safety Rules Symbol Signal Meaning SymbolsService Features Product SpecificationsON/OFF Switch Velcro STRAP/PUSH PinsKnow Your Laser Level TechnologyUnpacking AssemblyPacking List Operation Installing BatteriesApplications Turning ON/OFF Using the AIR-GRIP VacuumPositioning the Laser Level Using MULTI-FUNCTION Base Rough Surface AdaptorLoop Adjusting the Laser Line Operating the Laser Level See Figures 9Maintenance General MaintenanceTroubleshooting Problem Cause SolutionPage Ryobi TECHNOLOGIES, INC