ASSEMBLY
WARNING:
Always disconnect the bench grinder from the power source before performing any assembly or adjustment. Failure to do so could result in accidental starting result- ing in possible serious personal injury.
SPARK DEFLECTOR – BGH615
See Figure 4a.
Using two 6 mm hex bolts and washers, attach the spark deflector to the inside of the wheel guard.
Adjust the spark deflectors to within 1/16 in. of the grinding wheel. Tighten the hex bolts securely.
SPARK DEFLECTOR – BGH625 AND BGH825
See Figures 4b and 4c.
Using the two phillips head screws, washers, and lock washers, attach the spark deflector to the top of the wheel guard.
Adjust the spark deflectors to within 1/16 in. of the grinding wheel. Tighten the hex bolts securely.
WARNING:
Always spin the wheel by hand before turning on the grinder to make sure the spark deflector doesn’t hit the grinding wheel.
WARNING:
Always make sure your bench grinder is securely mounted to a workbench or an approved workstand. Failure to do so could result in an accident resulting in possible seri- ous personal injury.
WASHER
HEX BOLT
SPARK
DEFLECTOR
BGH615 | Fig. 4a |
SPARK DEFLECTOR
WASHER
SCREW
LOCK
WASHER
BGH625 | Fig. 4b |
SPARK DEFLECTOR
WASHER SCREW
LOCK
WASHER
BGH825 | Fig. 4c |
Page 11