ASSEMBLY
WORK REST – BGH615
See Figure 7a.
Mount the work rests to the inside of each wheel guard us- ing two hex bolts (8 mm x 8) and two washers (8 mm) on each side.
Before tightening the bolts, adjust the gap between the grinding wheel and the work rest to a maximum of 1/16 in. Tighten securely.
WORK REST – BGH625
See Figure 7b.
Mount the work rests to the work rest bracket using the knob, washer, and one hex nut.
Before tightening the bolts, adjust the gap between the grinding wheel and the work rest to a maximum of 1/16 in. Tighten securely.
WORK REST – BGH825
See Figure 7c.
Before attempting to mount the work rest, remove the hex nut and star washer from the phillips screw. See Figure 7c. Place the work rest over the phillips screw before replacing the hex nut and star washer. Using the hex bolt (5 mm x 10 mm) and washer (5 mm), secure the work rest against the inside of the wheel guard.
Before tightening the bolts, adjust the gap between the grinding wheel and the work rest to a maximum of 1/16 in. Tighten securely.
WORK
REST
HEX BOLTS | WASHERS |
| |
BGH615 | Fig. 7a |
HEX
NUT
WASHER
WORK REST
BRACKET
WORK
REST
KNOB
BGH625 | Fig. 7b |
PHILLIPS
SCREW
WORK
REST
STAR |
WASHER |
HEX BOLT | WASHER | HEX NUT |
|
| |
BGH825 | Fig. 7c | |
Page 13