ADJUSTMENTS
WARNING:
The hammer drill should never be connected to a power supply when you are assembling parts, making adjustments, cleaning, performing maintenance, or when the tool is not in use. Disconnecting the tool will prevent accidental starting that could cause serious injury.
ADJUSTING THE AUXILIARY HANDLE ASSEMBLY
See Figure 2.
Follow these steps to adjust the auxiliary handle assembly.
■Loosen the auxiliary handle assembly by turning the knob counterclockwise.
■Rotate the auxiliary handle assembly to the desired location.
■Tighten the auxiliary handle assembly securely by turning the knob clockwise.
ADJUSTING THE DEPTH GAUGE ROD
See Figure 3.
24
20
TO
| LOOSEN |
|
TO |
|
|
TIGHTEN | AUXILIARY |
|
|
| |
| HANDLE | Fig. 2 |
| ASSEMBLY |
TO DECREASE
DRILLING DEPTH TO INCREASE
Follow these steps to adjust the depth gauge rod.
■Lock the trigger switch by placing the rotation selector in the center position.
■Loosen the auxiliary handle assembly by turning the knob counterclockwise.
■Adjust the depth gauge rod so that the drill bit extends beyond the end of the rod to the required drilling depth.
■Tighten the auxiliary handle assembly by turning the knob clockwise.
DRILLING DEPTH 
DRILL BIT
DRILLING DEPTH DEPTH GAUGE ROD
24
20
AUXILIARY
HANDLE
ASSEMBLY
Fig. 3
Page 10