Ryobi HP1830M manual Specific Safety Rules, Service, Additional Rules for Safe Operation

Page 4

GENERAL SAFETY RULES

SERVICE

Tool service must be performed only by qualified repair personnel. Service or maintenance performed by unqualified personnel may result in a risk of injury.

When servicing a tool, use only identical replace- ment parts. Follow instructions in the Maintenance section of this manual. Use of unauthorized parts or failure to follow Maintenance Instructions may create a risk of shock or injury.

SPECIFIC SAFETY RULES

Hold tool by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator.

ADDITIONAL RULES FOR SAFE OPERATION

Know your power tool. Read operator's manual care- fully. Learn its applications and limitations, as well as the specific potential hazards related to this tool. Following this rule will reduce the risk of electric shock, fire, or serious injury.

Always wear safety glasses with side shields. Every- day glasses have only impact resistant lenses. They are NOT safety glasses.

IMPORTANT RULES FOR BATTERY TOOLS

Battery tools do not have to be plugged into an electrical outlet; therefore, they are always in operat- ing condition. Be aware of possible hazards when not using your battery tool or when changing accesso- ries. Following this rule will reduce the risk of electric shock, fire, or serious personal injury.

Do not place battery tools or their batteries near fire or heat. This will reduce the risk of explosion and possibly injury.

WARNING: Batteries vent hydrogen gas and can ex- plode in the presence of a source of ignition, such as a pilot light. To reduce the risk of serious personal injury, never use any cordless product in the presence of open flame. An exploded battery can propel debris and chemi- cals. If exposed, flush with water immediately.

Do not charge battery tool in a damp or wet location. Following this rule will reduce the risk of electric shock.

For best results, your battery tool should be charged in a location where the temperature is more than 50°F but less than 100°F. Do not store outside or in vehicles.

Under extreme usage or temperature conditions, bat- tery leakage may occur. If liquid comes in contact with your skin, wash immediately with soap and water, then neutralize with lemon juice or vinegar. If liquid gets into your eyes, flush them with clean water for at least 10 minutes, then seek immediate medical atten- tion. Following this rule will reduce the risk of serious personal injury.

Page 4

Image 4
Contents Operators Manual Save this Manual for Future ReferenceTable of Contents IntroductionGeneral Safety Rules Electrical SafetyPersonal Safety Work AreaSpecific Safety Rules ServiceImportant Rules for Battery Tools Additional Rules for Safe OperationImportant Safety Instructions for Charger Symbols Symbol Name DESIGNATION/EXPLANATIONSpecifications UnpackingApplications InstructionsAuxiliary Handle Assembly FeaturesDepth Gauge ROD Features Adjusting the Auxiliary Handle Assembly AdjustmentsAdjusting the Depth Gauge ROD Adjusting the Torque Changing the BIT Rotation Inserting BitsRemoving Bits RightOperation Charging Your DRILL-DRIVERTo Charge LED Function of ChargerTurning ON/OFF the Hammer Drill ReversibleThree Speed Gear Train To Install Battery Pack To Remove Battery PackBIT Storage Electric BrakeDrilling Removing the Chuck MaintenanceTightening the Chuck Battery Pack Preparation for Recycling Disposal of the Exhausted BatteryBatteries Service Model NO. and Serial no