Ryobi Drill Press manual General Safety Instructions, Transport and storage

Page 6

SAFETY INSTRUCTIONS

3 Muffler

Never use a machine that has a defective muffler.

Check regularly that the muffler is secured to the engine body.

4 Throttle lock

1Make sure the throttle control is locked at the idle setting when you release the throttle lock.

2Press the throttle lock and make sure it returns to its original position when you release it.

3Check that the throttle control and throttle lock move freely and that the return springs work properly.

4Start the power cutter and apply full throttle. Release the throttle control and check that the blade stops and remains stationary. If the blade rotates when the throttle is on idle setting you should check the carburettor idle adjustment. See the section on ”Maintenance”.

5 Blade guard for the cutting blade

Never use a defective blade guard or a blade guard that is not fitted correctly.

!WARNING! Check that the cutting blade is fitted correctly and does not show signs of damage. A damaged cutting blade can cause personal injury.

!WARNING! Never use a power cutter with defective safety equipment. The power cutter’s safety equipment should be checked and maintained as described in this Operator’s Manual. If your power cutter does not meet any of these controls you should contact your service workshop.

GENERAL SAFETY INSTRUCTIONS

IMPORTANT INFORMATION!

Do not use the power cutter until you have read the entire contents of this Operator’s Manual.

All servicing, in addition to the points listed in the section ”Control, maintenance and service of the power cutter’s safety equipment”, should be carried out by trained service specialists.

Use the equipment recommended in the chapter ”Personal safety equipment”.

Never use the machine when you are tired, under the influence of medicines/drugs or alcohol.

Do not lend the power cutter to anyone without providing this Operator’s Manual. Ensure the person using the power cutter understands the information in this Operator’s Manual.

Transport and storage

Store the power cutter under lock and key so that it’s out of reach for children and unauthorised persons.

Do not store or transport the power cutter with the cutting blade fitted.

6 – English

Image 6
Contents 371K 375K Symbol Explanation Symbols on the power cutterSymbols in the Operators Manual Contents Safety Instructions Stop switchAnti-vibration system Muffler Throttle lockBlade guard for the cutting blade General Safety Instructions Transport and storageCutting Fuel safetyBasic safety precautions Filling/Fuel mixture/StorageKickback Water coolingCare and storage GeneralAbrasive discs High speed portable toolsSpecial blades Using diamond blades Diamond bladesDiamond blades for dry cutting What is WHAT? What is what on a power cutter?Checking the drive shaft and flanges AssemblyFitting the cutting head Fitting the cutting blade Blade guardFuel Handling FuelmixFuelling Start and Stop Start and stopMaintenance Adjusting the drive belt Belt pulley and clutchChanging the drive belt Carburettor Fuel filter Air filterTensioning the recoil spring StarterReplacing a broken or worn starter cord Changing the broken recoil springSpark plug Cooling systemMuffler Daily maintenance Weekly maintenanceMonthly maintenance Technical Data 371K 375KCutting equipment EU declaration of conformity Only applies to Europe ´z+H2¶6`¨ 2003W14 114 01Also See