Ryobi SA60, SA720 manual Important Information for RECHARG- ING HOT Batteries

Page 14

OPERATION

IMPORTANT INFORMATION FOR RECHARG- ING HOT BATTERIES

When using your drill-driver continuously, the batteries be- come hot. You should let the batteries cool down for approxi- mately 30 minutes before attempting to recharge.

NOTE: This situation occurs when continuous use of your drill-driver causes the batteries to become hot. It does not occur under normal circumstances. Refer to “Charging Your Drill-Driver” earlier in this manual, for normal recharging of batteries. If the charger does not charge your batteries under normal circumstances, return both the drill-driver and charger to your nearest authorized service center for electrical check.

For more information on the battery recycling call

1-800-8 BATTERY.

WARNING:

If any parts are missing, do not operate tool until the missing parts are replaced. Failure to do so could result in possible serious personal injury.

TO INSTALL BATTERY PACK MODEL SA720

■Place the direction of rotation selector in center posi- tion. See Figure 9.

■Place the battery pack in your drill. Align raised rib on bat- tery pack with groove in drill's battery port. See Figure 10.

■Make sure the latches on each side of your battery pack snap in place and that battery pack is secured in drill before beginning operation.

TO REMOVE BATTERY PACK MODEL SA720

■Place the direction of rotation selector in center posi- tion. See Figure 9.

■Locate latches on side of battery pack and depress both sides to release battery pack from your drill. See Figure 10.

■Remove battery pack from your drill.

CAUTION:

When placing battery pack in your drill, be sure raised rib on battery pack aligns with groove in drill's battery port and latches snap in place properly. Improper assembly of battery pack can cause damage to inter- nal components.

DIRECTION

OF ROTATION SELECTOR

REVERSE

0

1

5

FORWARD

 

SWITCH

 

TRIGGER

Fig. 9

 

MODEL SA720

01

5

BATTERY

PACK

BATTERY

PORT

LATCHES

DEPRESS LATCHES

TO RELEASE

BATTERY PACK

Fig. 10

Page 14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Save this Manual for Future Reference Model SA60 Model SA720Table of Contents IntroductionGeneral Safety Rules Model Battery Pack ChargerSpecific Safety Rules ServiceImportant Safety Instructions for Charger Symbols Symbol Name DESIGNATION/EXPLANATIONApplications SpecificationsUnpacking InstructionsFeatures Level Torque Adjustment Ring BIT Model SA60Right AdjustmentsReversible See Figures 3 Installing BitsRemoving Bits WrongTo Decrease Torque Adjustable Torque ClutchTo Adjust Torque Screwdriver BitsOperation Charger Indicator Light LED Input Jack PlugBattery Chargerpack Input Jack Indicator Light LED Charging Your DRILL-DRIVERBattery Pack Port Latches Depress Latches To Release To Install Battery Pack Model SA720To Remove Battery Pack Model SA720 Important Information for RECHARG- ING HOT BatteriesSwitch DrillingLevel Drilling LevelChuck Removal MaintenanceGeneral MalletBatteries Battery Pack Removal and PREPARA- Tion for RecyclingTo Retighten a Loose Chuck Drill Handle Battery Lead Leadbattery Terminal Batteries Battery REMOVAL, Preparation for Recycling Model SA60Drill Handle Remove Cover Battery Cover See Figures 17Service Model NO. and Serial no
Top Page Image Contents