Ryobi RY6200 specifications To RIP CUT, To Assemble Optional RIP Guide

Page 17

OPERATION

TO RIP CUT

OPTIONAL RIP GUIDE (EDGE GUIDE)

See Figure 23.

Use a guide when making long or wide rip cuts with your saw. An optional rip guide with a five inch scale is available or you can make an efficient rip guide by clamping a straight edge to your workpiece. Secure the workpiece. Using C-clamps, firmly clamp a straight edge to the workpiece and guide the saw along the straight edge to achieve a straight rip cut. Do not bind the blade in the cut. If using the optional rip guide, see the following instructions and figure 24.

TO ASSEMBLE OPTIONAL RIP GUIDE

See Figure 24.

Remove battery pack from saw.

WARNING:

Failure to remove battery pack from saw could result in accidental starting causing possible serious personal injury.

Place rip guide through holes in saw base as shown in figure 24.

Adjust rip guide to the width needed.

Tighten rip guide screw (wing screw) securely.

When using a rip guide, position the face of the rip guide firmly against the edge of workpiece. This makes for a true cut without pinching the blade. The guiding edge of workpiece must be straight for your cut to be straight. Use caution to prevent the blade from binding in the cut.

STRAIGHT

EDGE

50 45

30 22

C-CLAMPS

WORKPIECE

 

ALTERNATE METHOD

Fig. 23

FOR RIP CUTTING

RIP

GUIDE SCREW (WING SCREW)

50

 

45

 

30

 

22

 

5

RIP GUIDE

4

3

(EDGE GUIDE)

2

 

1

 

0

PLACE RIP

GUIDE THRU HOLES

Fig. 24

Page 17

Image 17
Contents Thank YOU for Buying a Ryobi Cordless Circular SAW Operators ManualUnpacking Table of ContentsAccessories Read ALL Instructions Symbol Meaning Safety Alert SymbolRules for Safe Operation When Servicing USE only Identical Replacement Parts Important Safety Rules for Battery ToolsDo not Charge Battery Tool in a Damp or WET Location Important Safety Instructions for Circular Saws Important Safety Instructions for ChargerLower Blade Guard Do not Operate Charger with a DamagedRules for Safe Operation Switch FeaturesKnow Your Cordless Circular SAW ApplicationsOperation To Assemble or Remove Blade To Install Battery PackTo Remove Blade SAW BladesBlade Guard System Kickback is Caused by KickbackTo Lessen the Chance of Kickback KickbackStarting a CUT Depth of CUT AdjustmentTo Adjust Blade Depth To Help Maintain Control To Cross CUT or RIP CUT RIP Cuts Base AssemblyWidth of CUT Scale TOP View of SAW Guideline Front of SAW Blade Guide NotchGuard To Adjust Bevel SettingBlade Guide Notch Guideline Positive 0 Bevel Stop To AdjustTo Check To Pocket CUTTo Assemble Optional RIP Guide To RIP CUTBatteries MaintenanceBattery Pack Removal and Preparation for Recycling Page 2 in. Cordless Circular SAW Model NO. RY6200