Ryobi Table Saw manual Table of Contents, Product Specifications

TABLE OF CONTENTS

￿ Product Specifications	2
￿ Rules for Safe Operation	3-6
￿ Electrical	7
￿ Glossary of Terms	8
￿ Unpacking and Tools Needed	9
￿ Loose Parts List	10
￿ Features	11-13
Operating Components	12
On/Off Switch	12
To Turn Your Saw On	12
To Turn Your Saw Off	12
To Lock Your Saw Switch	12
Blades	13
￿ Assembly	14-19
Assembling Wheels and Hub Caps	14
Assembling Bumpers	14
Opening the Leg Stand	15
Closing the Leg Stand	16
To Install Rip Fence	17
Removing/Replacing the Throat Plate	17
Blade and Guard Assembly	18
To Check Saw Blade Installation	18
To Install Blade Guard Assembly	18
￿ Operation	20-30
Basic Operation	20
Causes of Kickback and Avoiding Kickback	20
Cutting Aids	20

Types of Cuts	21
Settings And Adjustments	22-25
To Remove The Blade	22
To Check, Replace or Adjust The Riving Knife
and Blade Guard Assembly	23
To Adjust the Blade Depth	24
To Adjust the Blade Angle	24
To Set the Scale to the Blade	24
Heeling (Paralleling) the Blade to the Miter Gage
Groove	25
To Use the Outfeed Support	26
To Use the Sliding Table Extension	26
Making Cuts	26-30
To Make a Cross Cut	26
To Make a Miter Cut	27
To Make a Straight Rip Cut	27
To Make a Bevel Cross Cut	28
To Make a Bevel Rip Cut	28
To Make a Compound Miter Cut	29
To Make Non-Through Cuts	29
To Make Dado Cuts	30
￿ Maintenance	30-31
General Maintenance	30
Lubrication	30
To Set Blade to 0 or 45 Degrees	31
To Check the Alignment of the Rip Fence to the
Blade	31
￿ Troubleshooting	32
￿ Parts Ordering / Service	34

PRODUCT SPECIFICATIONS

Blade Diameter	10 in. (254 mm)
Blade Arbor	5/8 in. (16 mm)
Cutting Depth at 0°	3-5/8 in. (92 mm)
Cutting Depth at 45°	2-1/2 in. (63.5 mm)
Rating	120 Volts, 60 Hz-AC Only, 15 Amperes
Output Speed	4,800 RPM
Net Weight	91.7 lbs. (41.6 kg.)

Page 2