Ryobi TS1353DXL manual Features, Product Specifications

Page 10

FEATURES

PRODUCT SPECIFICATIONS

Blade Arbor	5/8 in.
Blade Diameter	10 in.
No Load Speed	5,000/min.
Input	120 V, 60 Hz, AC only, 15 Amps
Net Weight	34.9 lbs.

Cutting Capacity with Miter at 0°/Bevel 0°:
Maximum nominal lumber sizes:	2 x 6, 4 x 4
Cutting Capacity with Miter at 45°/Bevel 0°:
Maximum nominal lumber sizes:	2 x 4
Cutting Capacity with Miter at 0°/Bevel 45°:
Maximum nominal lumber sizes:	2 x 6
Cutting Capacity with Miter at 45°/Bevel 45°:
Maximum nominal lumber sizes:	2 x 4

UPPER

BLADE

GUARD

DUST GUIDE

		BEVEL
		LOCK
		KNOB
		SLIDING
	SUPPORT	MITER
	SUPPORT	FENCE
	FOOT	FENCE
	FOOT
	BLADE
	WRENCH
	WRENCH

STOP BLOCK

TABLE

EXTENSIONS

SAW ARM

SWITCH TRIGGER

LOWER

BLADE GUARD

BEVEL SCALE
“NO HANDS ZONE”	“NO HANDS ZONE”
LABEL	BOUNDARY LINE
LABEL

			MITER SCALE
			THROAT PLATE
			MITER
	MITER	CONTROL	LOCK HANDLE
	MITER	CONTROL
	TABLE	ARM
	POSITIVE		MITER
BASE	STOP(S)		LOCK PLATE

Fig. 1

10

Image 10

Contents OPERATOR’S Manual Save this Manual for Future ReferenceTable of Contents IntroductionGeneral Safety Rules Read ALL InstructionsSpecific Safety Rules Specific Safety Rules Symbols Symbol Name DESIGNATION/EXPLANATIONService Electrical Connection ElectricalDouble Insulation Extension CordsGlossary of Terms Features Product SpecificationsAMP Motor Switch TriggerKnow Your Compound Miter SAW Blade Wrench StorageTools Needed Loose Parts List Mm HEX KEYUnpacking AssemblyMounting Holes Dust BAG To install the work clampDust Guide Work ClampSee Figures 12 Table ExtensionsStop Block Miter SAW BaseTighten blade bolt securely To Install / Replace the BladeSee Figures 16 Replace the lower blade guard and blade bolt coverMounting the Laser Guide Aligning the Laser Guide LineSquaring the Miter Table to the Fence See Figures 20Squaring the Blade to the Fence See Figures 24Squaring the Blade to the Miter Table See Figures 28Applications OperationTo Crosscut To Bevel CUT See Figures 32To Compound Miter CUT Compound Miter CUT Work ClampTo Support Long Workpieces See Figures 34Cutting Compound Miters Cutting Crown Molding Laying Molding Flat on the Miter TableClamping Wide Workpieces Cutting Warped MaterialSee Figures 38 Bevel Pivot Adjustment AdjustmentsPivot Adjustments Travel Pivot Adjustment Depth Stop AdjustmentsGeneral Maintenance MaintenancePositive Stop Adjustments Brush ReplacementSee Figures 44 Changing the BatteriesDo not attempt to activate the laser Service Model NO. and Serial no