Ryobi TS1353DXL manual Table Extensions, Stop Block, See Figures 12, Miter SAW Base

Page 16

ASSEMBLY

TABLE EXTENSIONS

See Figures 12 - 14.

To use the stop block, slide the stop block on the back arm of the desired table extension first.

To install table extensions, insert the ends of extensions into the holes in the sides of the base. See Figures 13 - 14. Adjust the extensions to the desired length.

Secure extensions in place by positioning a clamp bracket under each table extension beneath the miter table. Orient each clamp bracket as shown in figure 14.

Secure each clamp bracket in place with a clamp bracket screw. The clamp bracket screw threads through the clamp bracket and tightens against bracket support on bottom of miter table, securing clamp bracket against table extension.

STOP BLOCK

See Figures 12 and 15.

The stop block is included with the table extensions and is useful as a stop for making repetitive cuts to the same length. It can be installed on either side of the saw base:

n Slide the stop block on the back arm of either table extension, then insert the table extensions into the saw base.

nUse the small wing screw to secure the stop block to the table extensions.

�n Loosen the small wing screw and adjust the stop block the desired distance from the blade for the cut to be made. For accurate placement of the stop block, measure the distance from the teeth set on the blade to the stop block.

�n Tighten wing screw securely. �n Plug the saw in.

�n Make a test cut in scrap material and measure the length of the workpiece.

�n Make any necessary adjustments.

STOP BLOCK

SMALL

WING

SCREW

TABLE

EXTENSION

BASE

Fig. 12

TABLE

EXTENSION

MITER SAW BASE

Fig. 13

 

SAW VIEWED FROM BOTTOM

 

BRACKET

MITER

SUPPORT

SAW

 

BASE

 

TABLE

CLAMP

BRACKET

EXTENSION

ASSEMBLED

CLAMP

BRACKET

CLAMP

 

BRACKET SCREW

Fig. 14

STOP

BLOCK

Fig. 15

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents OPERATOR’S Manual Save this Manual for Future ReferenceTable of Contents IntroductionGeneral Safety Rules Read ALL InstructionsSpecific Safety Rules Specific Safety Rules Symbols Symbol Name DESIGNATION/EXPLANATIONService Electrical Double InsulationElectrical Connection Extension CordsGlossary of Terms Features Product SpecificationsSwitch Trigger Know Your Compound Miter SAWAMP Motor Blade Wrench StorageTools Needed Loose Parts List Mm HEX KEYUnpacking AssemblyMounting Holes To install the work clamp Dust GuideDust BAG Work ClampTable Extensions Stop BlockSee Figures 12 Miter SAW BaseTo Install / Replace the Blade See Figures 16Tighten blade bolt securely Replace the lower blade guard and blade bolt coverMounting the Laser Guide Aligning the Laser Guide LineSquaring the Miter Table to the Fence See Figures 20Squaring the Blade to the Fence See Figures 24Squaring the Blade to the Miter Table See Figures 28Applications OperationTo Crosscut To Bevel CUT See Figures 32To Compound Miter CUT Compound Miter CUT Work ClampTo Support Long Workpieces See Figures 34Cutting Compound Miters Cutting Crown Molding Laying Molding Flat on the Miter TableClamping Wide Workpieces Cutting Warped MaterialSee Figures 38 Adjustments Pivot Adjustments Travel Pivot AdjustmentBevel Pivot Adjustment Depth Stop AdjustmentsMaintenance Positive Stop AdjustmentsGeneral Maintenance Brush ReplacementSee Figures 44 Changing the BatteriesDo not attempt to activate the laser Service Model NO. and Serial no
Top Page Image Contents