Ryobi TS1353DXL manual Tools Needed

Page 12

FEATURES

POSITIVE STOPS ON MITER TABLE

Positive stops have been provided at 0°, 15°, 22-1/2°, 30°, and 45°. The 22-1/2°and 45° positive stops have been provided on both the left and right side of the miter table.

BEVEL LOCK KNOB

The bevel lock knob securely locks your compound miter saw at desired bevel angles. Positive stop adjustment screws have been provided on each side of the saw arm. These adjustment screws are for making fine adjustments at 0° and 45°.

ELECTRIC BRAKE

An electric brake has been provided to quickly stop blade rotation after the switch is released.

LASER GUIDE

For more accurate cuts, a laser guide is included with the miter saw. When used properly, the laser guide makes ac- curate, precision cutting simple and easy.

SLIDING MITER FENCE

The miter fence on the compound miter saw has been provided to hold your workpiece securely against when making all cuts. The left side is larger providing additional support. It has a sliding feature for clearance of the saw arm when making bevel or compound cuts.

Loosen the fence screw before attempting to slide the miter fence. Once the desired position of the miter fence is deter- mined, tighten the fence screw to secure the sliding fence.

SELF-RETRACTING LOWER BLADE GUARD

The lower blade guard is made of shock-resistant, see- through plastic that provides protection from each side of the blade. It retracts over the upper blade guard as the saw is lowered into the workpiece.

SUPPORT FOOT

A swingout support foot has been added to provide additional stability for the miter saw.

TOOLS NEEDED

The following tools (not included) are needed for making adjustments or installing the blade:

COMBINATION WRENCH (2)

 

(10 mm, 12 mm)

HEX KEY

 

 

(6 mm)

COMBINATION

SQUARE FRAMING SQUARE

Fig. 5

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents OPERATOR’S Manual Save this Manual for Future ReferenceTable of Contents IntroductionGeneral Safety Rules Read ALL InstructionsSpecific Safety Rules Specific Safety Rules Symbols Symbol Name DESIGNATION/EXPLANATIONService Electrical Double InsulationElectrical Connection Extension CordsGlossary of Terms Features Product SpecificationsSwitch Trigger Know Your Compound Miter SAWAMP Motor Blade Wrench StorageTools Needed Loose Parts List Mm HEX KEYAssembly UnpackingMounting Holes To install the work clamp Dust GuideDust BAG Work ClampTable Extensions Stop BlockSee Figures 12 Miter SAW BaseTo Install / Replace the Blade See Figures 16Tighten blade bolt securely Replace the lower blade guard and blade bolt coverMounting the Laser Guide Aligning the Laser Guide LineSquaring the Miter Table to the Fence See Figures 20Squaring the Blade to the Fence See Figures 24Squaring the Blade to the Miter Table See Figures 28Operation ApplicationsTo Crosscut To Bevel CUT See Figures 32To Compound Miter CUT Compound Miter CUT Work ClampTo Support Long Workpieces See Figures 34Cutting Compound Miters Cutting Crown Molding Laying Molding Flat on the Miter TableCutting Warped Material Clamping Wide WorkpiecesSee Figures 38 Adjustments Pivot Adjustments Travel Pivot AdjustmentBevel Pivot Adjustment Depth Stop AdjustmentsMaintenance Positive Stop AdjustmentsGeneral Maintenance Brush ReplacementChanging the Batteries See Figures 44Do not attempt to activate the laser Service Model NO. and Serial no
Top Page Image Contents