ASSEMBLY
REMOVING BLADE
See Figure 4.
nUnplug the saw.
nDepress spindle lock button.
nRemove blade screw by turning it counterclockwise with the wrench.
nRemove spring washer and outer blade washer (“D” washer).
nLift lower blade guard.
nRemove blade.
EDGE GUIDE
See Figure 5.
Use the edge guide when making long or wide rip cuts with the saw.
nUnplug the saw.
nPlace edge guide through holes in base.
nAdjust edge guide to the width needed.
nTighten edge guide knob securely.
DUST NOZZLE KIT
See Figure 6.
The dust nozzle kit directs saw dust away from the operator. The adaptor fits over the dust chute which is located on the upper blade guard. The nozzle attaches to the adaptor.
NOTE: If you use the nozzle, you should always connect it to a standard vacuum hose.
nUnplug the saw.
nLift lower blade guard.
nOrient adaptor to fit into the dust chute opening on upper blade guard.
nSecure adaptor with screw provided.
nAlign hole in nozzle with raised lip on adaptor and snap into place when using a vacuum hose.
SPINDLE
LOCK BUTTON
BLADE
SCREW
WRENCH
Fig. 4
EDGE GUIDE
KNOB
EDGE GUIDE
Fig. 5
NOZZLE | DUST CHUTE |
| OPENING |
| RAISED LIP |
ADAPTOR
SCREW
HOLE
Fig. 6
12