Ryobi MS180 warranty To Install Blade, Blade Bolt Cover Phillips Screw, Phillips Screw Blade Bolt

ADJUSTMENTS

TO INSTALL BLADE

See Figures 15, 16, 17 and 18.

DANGER:

A 8-1/4 in. (209.6 mm) blade is the maximum blade capacity of your saw. Never use a blade that is too thick to allow outer blade washer to engage with the flats on the spindle. Larger blades will come in contact with the blade guards, while thicker blades will prevent the blade bolt from securing the blade on the spindle. Either of these situations will result in a serious accident and can cause serious personal injury.

■Remove battery pack from saw.

WARNING:

Failure to remove battery pack from your saw could result in accidental starting causing possible serious personal injury.

■Push down on the saw arm and pull out the lock pin to release saw arm. Raise saw arm to its full raised position. Be cautious, saw arm is spring loaded to raise.

■Loosen the phillips screw on the blade bolt cover until blade bolt cover can be raised. See Figure 15.

■Gently raise the lower blade guard bracket, releasing lower blade guard from notch so that lower blade guard and blade bolt cover can be rotated up and back to expose the blade bolt. See Figure 16.

BLADE BOLT COVER

PHILLIPS SCREW

R O T A T I O N

Fig. 15

LOWER

LOWER BLADEBLADE GUARD GUARD BRACKET

NOTCH

PHILLIPS

SCREW

	BLADE BOLT
	Fig. 16
BLADE	LOWER
	BLADE GUARD
BOLT COVER

	PHILLIPS
	SCREW
	FLAT (S)
	ON SPINDLE
TO	INNER BLADE
LOOSEN
	WASHER WITH
	DOUBLE "D" FLATS
	R O
	T A T I O N
	TO
	TIGHTEN
	BLADE
BLADE BOLT
	OUTER BLADE WASHER
	WITH DOUBLE "D" FLATS
	Fig. 17

16