Ryobi C2600 warranty Power Supply, Switch, Cutting with Your CUT-OFF Machine, Vise

OPERATION

POWER SUPPLY

Before operating your cut-off machine, check your power supply and make sure it meets the requirements listed on the tool’s data plate. A substantial voltage drop will cause a loss of power and machine overheating.

Common causes of power loss and machine overheating are insufficient extension cord size and multiple tools operating from the same power source.

SWITCH

To turn your cut-off machine ON, depress the switch trigger located in the handle portion of the machine arm.

To turn it OFF, release the switch trigger.

LOCK-ON BUTTON

To engage the lock-on feature, depress the switch trigger, push in and hold the lock-on button located on the side of the handle, then release switch trigger. Release lock-on button and your machine will continue running.

To release the lock-on feature, depress the switch trigger and release.

If you have the lock-on feature engaged during use and your machine becomes disconnected from power supply, or in the event of a power failure, disengage the lock-on feature immediately.

CUTTING WITH YOUR CUT-OFF MACHINE

See Figures 12 and 13.

WARNING:

Do not attempt to cut wood or masonry with this cut-off machine. Never cut magnesium or magnesium alloy with this machine. Failure to comply could result in serious personal injury.

■To prevent machine movement or tipping during cutting procedure, secure cut-off machine in place to a workbench or work surface that is also secure.

MACHINE ARM	SWITCH
(HANDLE)	TRIGGER
LOCK-ON
BUTTON

MATERIAL

TO BE CUT

15

0

MACHINE

BASE

Fig. 12

ADJUSTABLE	EXTENSION
	BLOCK
FLIP FENCE
	VISE
	CLAMP
	45
	30
	15
	0
“C” CLAMP
AREA
MATERIAL
TO BE CUT	Fig. 13

WARNING:

Always use the vise on the cut-off machine to prevent accidents that could result in possible serious personal injury.

WARNING:

Never stand or have any part of your body in line with the path of the wheel. Doing so may cause an accident resulting in possible serious personal injury.

WARNING:

Large, circular, or irregularly shaped material may require additional means of clamping to be secured in place adequately for cutting. Use “C” clamps that can be mounted along the left and front side of the machine base. Also use blocks to hold material securely. Failure to comply could result in serious personal injury.

WARNING:

To avoid accidental start up of your cut-off machine, always make sure switch is off and “lock-on” feature is disengaged before connecting to power source. Failure to heed this warning could result in serious personal injury.

Page