Ryobi C2600 warranty Carrying Handle, LOCK-ON Button, Spindle Lock Button, Trigger Lock

Page 9

FEATURES

CARRYING HANDLE

See Figure 3.

For convenience when carrying or transporting your cut-off machine from one place to another, a carrying handle has been provided on top of the machine arm as shown figure 3. To transport, turn off and unplug your machine, then lower machine arm and lock it in the down position. Lock machine arm by pushing in arm lock lever.

LOCK-ON BUTTON

See Figure 3.

Your cut-off machine is equipped with a lock-on feature, which is convenient when continuous cutting for extended periods of time is required. To engage the lock-on feature, depress switch trigger, push in and hold the lock-on button located on the side of the handle, then release switch trigger. Release lock-on button and machine will continue running.

To release lock-on feature, depress switch trigger and release.

If you have the lock-on feature engaged during use and your machine becomes disconnected from power supply, disengage the lock-on feature immediately.

SPINDLE LOCK BUTTON

A spindle lock button has been provided for locking the spindle which keeps the wheel in your machine from rotating. Depress and hold the spindle lock button while installing, changing, or removing wheel only.

TRIGGER LOCK

See Figure 4.

To prevent unauthorized use of your cut-off machine, we suggest that you disconnect it from the power supply and lock the switch in the off position. To lock the switch, install a padlock (not included) through the hole in the switch trigger. A lock with a shackle up to 13/64 in. diameter may be used. When the lock is installed and locked, the switch is inoperable. Store the padlock key in another location.

SWITCH TRIGGER

PADLOCK

Fig. 4

CARRYING HANDLE

LOCK-ON

BUTTON

SPINDLE

MACHINE ARM

LOCK BUTTON

 

UPPER

WHEEL GUARD

POWER CORD

ARM

LOCK

LEVER

WRENCH

STORAGE

30

15

SWITCH TRIGGER

LOWER

WHEEL GUARD

14 in. (356 mm)

ABRASIVE WHEEL

QUICK LOCK-

RELEASE LEVER

0

8 mm

 

 

 

HEX KEY

ADJUSTABLE

 

VISE CRANK

FENCE

 

HANDLE

LOCK HANDLE

FLIP FENCE

VISE CLAMP

 

RUBBER FEET

ASSEMBLY

MACHINE BASE

Fig. 3

 

 

 

 

Page

 

 

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Thank YOU for Buying a Ryobi Abrasive CUT-OFF Machine Save this Manual for Future ReferenceTable of Contents Symbol Meaning Safety Alert Symbol Rules for Safe OperationGrinding Wheel Institute Read ALL Instructions Before Making a CUT, be Sure ALL Adjustments are Secure Extension Cords ElectricalElectrical Connection Grounding InstructionsProduct Specifications Loose Parts ListUnpacking and Loose Parts Features LOCK-ON Button Carrying HandleSpindle Lock Button Trigger LockRemoval and Installation of Wheel To Remove AdjustmentsTo Install Spacer Wheel Bolt Outer FlangeCutting Angle Adjustment Adjustable Flip FenceAdjusting Width of CUT Scale Indicator FenceTo Tighten Using the Quick LOCK-RELEASE Lever and Vise Clamp To LoosenSee Figures 9 Vise Crank HandleOperation Depth Stop AdjustmentsDepth Stop ApplicationsSwitch Power SupplyCutting with Your CUT-OFF Machine Material To be CUT Machine BaseCUT-OFF See Figures 14Vise Crank Handle Machine Base Mounting Holes MaintenanceGeneral LubricationBrush Replacement TroubleshootingProblem Cause Solution Brush CAP AssemblyTroubleshooting Ryobi Canada INC Ryobi America Corporation
Top Page Image Contents