Ryobi C2600 Troubleshooting, Brush Replacement, Problem Cause Solution, Brush CAP Assembly

Page 17

MAINTENANCE

WARNING:

To ensure safety and reliability, all repairs — with the exception of the externally accessible brushes — should be performed by a Ryobi Authorized Service Center.

BRUSH REPLACEMENT

See Figure 17.

Your cut-off machine has externally accessible brush assemblies that should be periodically checked for wear.

Proceed as follows when replacement is required:

Unplug your cut-off machine.

WARNING:

Failure to unplug cut-off machine could result in accidental starting causing possible serious personal injury.

Remove brush cap with a screwdriver. Brush assembly is spring loaded and will pop out when you remove brush cap.

Remove brush assembly.

Check for wear. Replace both brushes when either has less than 1/4 in. length of carbon remaining. Do not replace one side without replacing the other.

Reassemble using new brush assemblies. Make sure curvature of brush matches curvature of motor and that brush moves freely in brush tube.

BRUSH CAP

BRUSH

ASSEMBLY

BRUSH

ASSEMBLY

BRUSH

 

CAP

Fig. 17

Make sure brush cap is oriented correctly (straight) and replace.

Tighten brush cap securely. Do not overtighten.

TROUBLESHOOTING

PROBLEM

CAUSE

SOLUTION

Machine does not start

1.

Power cord not plugged in.

 

2.

Power cord is damaged.

1.Plug in cord.

2.Have the cord replaced at your nearest authorized service center.

3.Circuit breaker is tripped.

4.Circuit fuse is blown

5.Switch is damaged or burned out.

3.Reset circuit breaker.

4.Replace circuit fuse.

5.Have the switch replaced at your nearest authorized service center and request a voltage check from the power company.

Page

Image 17
Contents Thank YOU for Buying a Ryobi Abrasive CUT-OFF Machine Save this Manual for Future ReferenceTable of Contents Grinding Wheel Institute Symbol Meaning Safety Alert SymbolRules for Safe Operation Read ALL Instructions Before Making a CUT, be Sure ALL Adjustments are Secure Extension Cords ElectricalElectrical Connection Grounding InstructionsUnpacking and Loose Parts Product SpecificationsLoose Parts List Features LOCK-ON Button Carrying HandleSpindle Lock Button Trigger LockRemoval and Installation of Wheel To Remove AdjustmentsTo Install Spacer Wheel Bolt Outer FlangeCutting Angle Adjustment Adjustable Flip FenceAdjusting Width of CUT Scale Indicator FenceTo Tighten Using the Quick LOCK-RELEASE Lever and Vise Clamp To LoosenSee Figures 9 Vise Crank HandleOperation Depth Stop AdjustmentsDepth Stop ApplicationsSwitch Power SupplyCutting with Your CUT-OFF Machine Material To be CUT Machine BaseVise Crank Handle Machine Base CUT-OFFSee Figures 14 Mounting Holes MaintenanceGeneral LubricationBrush Replacement TroubleshootingProblem Cause Solution Brush CAP AssemblyTroubleshooting Ryobi Canada INC Ryobi America Corporation