Grizzly G1095/G1096 owner manual Box Inventory Figures 4 Qty

Page 16

Inventory

The following is a description of the main compo- nents shipped with your machine. Lay the compo- nents out to inventory them.

Note: If you can't find an item on this list, check the mounting location on the machine or examine the packaging materials carefully. Occasionally we pre-install certain components for shipping purposes.

Box Inventory (Figures 4 & 5)		Qty
A.	Power Feeder Assembly	1
B.	Lubricator	1
C.	Base and Column Assembly	1
D.	Elbow Joint Assembly	1
E.	Base Bolt Pattern Template	1
F.	Handwheel Handle	1
G.	Horizontal Column Assembly	1

SUFFOCATION HAZARD!

Immediately discard all plas- tic bags and packing materi- als to eliminate choking/suf- focation hazards for children and animals.

-14-

If any nonproprietary parts are missing (e.g. a nut or a washer), we will gladly replace them; or for the sake of expediency, replacements can be obtained at your local hardware store.

A		B

Figure 4. Power feeder inventory.

C

D

E

F

G

Figure 5. Support and base inventory.

Model G1095/G1096 1-HP Power Feeder

Image 16

Contents HP Power Feeder Ss ,EAD from Leadbased PAINTS Table of Contents Foreword Functional Overview IntroductionContact Info Machine Data Sheet Other Model G1096 Power Feeder 4 Roller / 4 Speed Phase Model G1095/G1096 1-HP Power Feeder Controls and features Model G1095/G1096 1-HP Power Feeder Identification !,7!93 53% !.3 !002/6%$$ 3!&%49 ,!33%33 7%. /0%2!4 !,7!93 53%3 %!2.2 02/4%#4/ %. /0%2!4.! -!#.%29 53%3!!2/5.$%$ %84%.3/..#/2$ 2!4%$4&/2/4%-!#.%!-0%2!%2 53%3 2%#/--%.$%$- !##%33/2%3 -!.9 -!#.%3 #!. %*%#4 7/2+0%#%3 4/7!2$ /0%2!4/2 !,7!93 ,/#+ -/,% !3%3 & 53%$ % %&/2% /0%2!4. -!#.%29#Additional Safety for Power Feeders 220V Single-Phase Operation G1095 Circuit Requirements220V Three-Phase Operation G1096 Nema 15-15 plug and receptacleSetup Setup SafetyItems Needed for Setup UnpackingInventory Box Inventory Figures 4 QtyHardware Recognition Chart Clean Up Assembly Assembled power feeder Model G1095/G1096 1-HP Power FeederBase Mounting Shaper Jointer TablesawThrough-Bolt Mounting To test run the power feeder Test RunOperation Safety Basic Use and Care OperationsTo change the feed rate of your power feeder Changing SpeedsFt Per Min A, 25 Tooth + B Ft Per Min A, 40 Tooth + BMaintenance CleaningSchedule LubricationService TroubleshootingWheel Replacement Wiring Electrical Safety InstructionsElectrical IgZZEVhZ Parts FeederDescription Stand and Support Assembly 22!.49 #!2$ 99.$5342!, .# 0//88 %,,.!- 7! Warranty and Returns #ALL 4ODAYD&ORO! &2%%