Grizzly G1095/G1096 owner manual Wheel Replacement

Page 26

Wheel Replacement

Always disconnect power to the machine before performing installation or maintenance. Failure to do this may result in serious personal injury.

To replace a worn out or damaged wheel:

1.DISCONNECT THE POWER FEEDER FROM POWER!

2.Using a 5mm hex wrench, remove the wheel retaining cap screws (Figure 17).

-24-

Cap

Screw

Figure 17. Wheel cap screws.

3.Swap the old wheel with the new one.

4.Reinstall the four cap screws, and tighten in an alternating pattern until the wheel is tight.

Model G1095/G1096 1-HP Power Feeder

Image 26

Contents HP Power Feeder Ss ,EAD from Leadbased PAINTS Table of Contents Contact Info IntroductionForeword Functional Overview Machine Data Sheet Other Model G1096 Power Feeder 4 Roller / 4 Speed Phase Model G1095/G1096 1-HP Power Feeder Controls and features Model G1095/G1096 1-HP Power Feeder Identification !,7!93 53% !.3 !002/6%$$ 3!&%49 ,!33%33 7%. /0%2!4 !,7!93 53%3 %!2.2 02/4%#4/ %. /0%2!4.! -!#.%29 -!.9 -!#.%3 #!. %*%#4 7/2+0%#%3 4/7!2$ /0%2!4/2 53%3!!2/5.$%$ %84%.3/..#/2$ 2!4%$4&/2/4%-!#.%!-0%2!%2 53%3 2%#/--%.$%$- !##%33/2%3 !,7!93 ,/#+ -/,% !3%3 & 53%$ % %&/2% /0%2!4. -!#.%29#Additional Safety for Power Feeders 220V Single-Phase Operation G1095 Circuit Requirements220V Three-Phase Operation G1096 Nema 15-15 plug and receptacleItems Needed for Setup SetupSetup Safety UnpackingInventory Box Inventory Figures 4 QtyHardware Recognition Chart Clean Up Assembly Assembled power feeder Model G1095/G1096 1-HP Power FeederBase Mounting Shaper Jointer TablesawThrough-Bolt Mounting To test run the power feeder Test RunOperation Safety Basic Use and Care OperationsFt Per Min A, 25 Tooth + B To change the feed rate of your power feederChanging Speeds Ft Per Min A, 40 Tooth + BSchedule MaintenanceCleaning LubricationService TroubleshootingWheel Replacement Wiring Electrical Safety InstructionsElectrical IgZZEVhZ Parts FeederDescription Stand and Support Assembly 22!.49 #!2$ 99.$5342!, .# 0//88 %,,.!- 7! Warranty and Returns #ALL 4ODAYD&ORO! &2%%