Operation Instructions
1.Read the drying directions for the type of paint being used. Multiple layers of paint may effect proper drying time.
2.The object to be dried should be placed between 12” and 20” from the Lamp. Refer to instructions for the paint being used.
3.Clear area of all potentially flammable items, including those that may melt or be damaged by heat. Never use near fuel, fuel lines, or oil of any sort.
4.To adjust the height of the Lamp, turn the knob on the Connector (6) counterclockwise and slide the Lamp Head (9) up or down along the Top Pole (5) until the desired height is reached. Turn the knob on the Connector (6) clockwise until the Connector is secured in place.
5.To Adjust the angle of the Lamp Head (9), turn the Wing Nut (8) counterclockwise until the Connector Bolt (7) loosens, allowing the angle of the Lamp Head (9) to be adjusted. Once the desired angle is found, turn the Wing Nut (8) clockwise to secure the Lamp Head (9) in place.
6.Plug the Lamp into a
(9) to the “ON” position.
7.Make sure the Lamp is on a flat, level surface to prevent rolling. When moving the Lamp, slowly guide the Lamp along the floor by pulling on the center of the Bottom Pole (1) to avoid danger of tipping.
8.Monitor Lamp and adjust as necessary to ensure quality finish.
9.Allow the Lamp to cool before moving and do not touch the Lamp bulb with bare fingers.
Caution: Keep fingers and all objects clear of Lamp at all times. When in use, and immediately afterwards, the bulb will be hot and could cause injury if touched.
INSPECTION, MAINTENANCE, AND CLEANING
1.
WARNING! Make sure the Power Switch of the Lamp is in its “OFF” position, that the tool is unplugged from its electrical outlet, and that the unit is allowed to cool completely before performing any inspection, maintenance, or cleaning procedures.
2.BEFORE EACH USE, inspect the general condition of the Lamp. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged electrical wiring, and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use.
Do not use damaged equipment.
SKU 97641 | For technical questions, please call | Page 9 |