Multiquip GX390K1SM32 Checking The Vibrator Oil Level, Vibrator Oil Level Plug, Checking Scrapers

Checking The Vibrator Oil Level

1.Check vibrator casing for any oil leakage.

2.If any leakage is noticed, remove the level plug on the side of the plate (Figure 9).

3.Check the oil level.

Vibrator Oil

Level Plug

Figure 9. Checking Vibrator Oil Level

Fuel Check

1.Remove the fuel cap located on top of the engine fuel tank.

2.Visually inspect to see if the fuel level is low. If fuel is low, replenish with unleaded gasoline using a strainer for filtration. DO NOT top-off fuel. Wipe up any spilled fuel immediately!

DANGER

Motor fuels are highly flammable and can be dangerous if mishandled. DO NOT smoke while refueling.

DO NOT attempt to refuel the pump if the engine is hot! or running.

Checking Water Tank

1.Check the water tank to see if filled. Add water if necessary. The water tank has a capacity of approximately 10 gallons (40 liters) (Figure 10).

Figure 10. Checking Water Tank

CAUTION :

Be careful not to confuse the water tank with the oil tank.

MRH800GS — INSPECTION

Checking Levers and Horn

1.Check travel, vibration, and throttle levers to make sure they are functioning properly (Figure 4).

2.With travel lever placed in reverse, push the deadman device and verify that the travel lever returns to neutral position.The travel lever stays in neutral position once the deadman device is released.

3.Press the horn and verify that it functions properly.

Checking Scrapers

1.Check scrapers and make sure that they are not clogged with mud, bent or damaged (Figure 11).

2.Adjust clearance between drums and scrapers as necessary.

Scrapers

Figure 11. Checking Scrapers

Checking Bolts, Nuts and Screws

1.Check bolts, nuts, and screws on various parts of the machine, including the engine, for proper tightness.

Positioning the Handle Bar

1.Release the handle bar release pin (Figure 12) and position the handle bar to the lowered position before starting operation.

2.When machine is not in use, release the handle bar release pin and position the handle bar to the upright position.

Handle Bar

Release Pin

Figure 12. Positioning the Handle Bar

MQ-MIKASA MRH800GS ROLLER — OPERATION AND PARTS MANUAL — REV. #5 (05/27/08) — PAGE 23