Graco 332574D important safety instructions Replace Anvil, Adjust Anvil to Cutter Head Tension

Replace Anvil

AK	AH
		AC	AD
AG
			AA
AP
		AN	AB
AF	AE AJ
FIG. 5

For part references, see FIG. 5 on this page and cutter parts illustration on page 20.

1.Follow Pressure Relief Procedure found within the RS Gun and Cutter, Operation-Repair manual.

2.Engage trigger lock.

3.Loosen knob (628) then remove cover (627). See page 20.

Blades are sharp. Always wear protective gloves to prevent cuts when the cutter cover is removed.

4.Use hand to prevent anvil from spinning, then push in and rotate anvil cap (AD) 90 degrees coun- ter-clockwise to remove.

5.Loosen the anvil to blade tension lockdown lever (AG).

6.Use the anvil to blade tension adjustment knob (AF) to relieve the tension between the anvil and blades.

Maintenance

7.Remove anvil (AC).

8.Install new anvil onto sleeve.

9.Install anvil cap.

10.Install cover and knob.

NOTICE

More tension between the anvil and blades leads to the anvil and blades wearing out faster. To prevent premature wear and to maximize anvil and blade life, use the minimum tension required to cut the glass and make small increases in tension when strands are not cut correctly.

11.Adjust Anvil to Cutter Head Tension, page 8.

332574D 11