Hobart Welding Products 210, M-10 installation instructions Holding And Positioning Welding Gun

6-3. Holding And Positioning Welding Gun

NOTE

Welding wire is energized when gun trigger is pressed. Before lowering helmet and pressing trigger, be sure wire is no more than 1/2 in (13 mm) past end of nozzle, and tip of wire is positioned correctly on seam.

	1			1	Hold Gun and Control Gun
					Trigger
				2	Workpiece
			3	3	Work Clamp
		2		4	Electrode Extension (Stickout)
					1/4 to 1/2 in (6 To 13 mm)
				5 Cradle Gun and Rest Hand on
5					Workpiece
	4
		0°-15°
90°	90°
End View of Work Angle		Side View of Gun Angle
	GROOVE WELDS
	45°	0°-15°
45°
End View of Work Angle		Side View of Gun Angle
	FILLET WELDS				S-0421-A

OM-927 Page 32