Hobart Welding Products 180, H-10 GUN manual Operation, Controls

SECTION 6 − OPERATION

6-1. Controls

1 2

1 Wire Speed Control

Use control to select a wire feed speed. As Voltage switch setting increases, wire speed range also increases (see weld setting label in welding power source or Sections 6-2or 6-3, as applicable).

2 Power Switch

3	4
2	DO NOT SWITCH
	WHILE WELDING
	NE PAS CHANGER
	DE PROCÉDÉ

1P U R G E

V

34

Ref. 217 617-A

3 Voltage Switch	4 Voltage Switch - “Purge” Position
The higher the selected number, the	In purge position, fan runs but there is no
thicker the material that can be welded	weld output or wire feed. Use “PURGE”
(see weld setting label in welding power	setting when adjusting gas flow at the
source or Sections 6-2and 6-3,as	regulator.
applicable). Do not switch under load.

.Switch must “click” into detent position 1, 2, 3, 4, or purge for proper contact.

OM-925 Page 19