3-4. Threading Welding Wire
1 Wire Spool
2 Welding Wire
3 Inlet Wire Guide
4 Pressure Adjustment Knob
5 Drive Roll
6 Gun Cable
Lay gun cable out straight.
4
Tools Needed:
6
1 | 2 | 3 | 5 |
|
|
|
|
Open pressure assembly.
Tighten
.Hold wire tightly to keep it from unraveling.
6 in | 4 in |
(150 mm) | |
| (102 mm) |
Pull and hold wire; cut off end. | Push wire thru guides into gun liner; |
| continue to hold wire. |
.Rotate pressure adjustment knob in a clockwise direction
until drive roll is tight against the welding wire. Adjust drive roll pressure just tightly enough to prevent wire from slipping on or against drive roll during operation.
INPUT POWER
Be sure that wire is positioned
in proper feed roll groove. Close and tighten pressure assembly, and let go of wire.
Press gun trigger until wire comes out of gun.
Remove gun nozzle and contact tip. | Turn power on. |
.Tip adapter may also require removal to allow wire to feed out end of gun.
Tighten
|
|
| WOOD |
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
| ||
Be sure that contact tip matches wire diameter. | Feed wire to check drive roll pressure. | ||||||
Reinstall tip adapter, if applicable, contact tip | Tighten knob enough to prevent slipping. | ||||||
and nozzle. | Cut off wire. Close door. | ||||||
Ref. 803