2.Place the pivot ball housing (F) Fig. 7 in the sleeve (G) of stock feeder. NOTE: Position the slot in the pivot ball housing (F) "up" (Fig. 8).
3.Insert the overarm (B) Fig. 9 with pivot ball (A) attached, through the housing (F) until the pivot ball (A) is inside the housing (F). Bring the overarm (B) Fig. 10 over and inside the slot in pivot ball housing (F). Push the pivot ball and the overarm (A) forward until the pivot ball is at the front of housing (F).
4.Insert the round end of the pivot ball cover (H) Fig. 10 into the rear of the housing (F) Fig. 11, and over the pivot ball.
NOTE: Make certain that the wider slots in the pivot ball cover (H) Fig. 11 are positioned horizontally inside of the housing (F).
G | F |
Fig. 7
G
F
Fig. 8
B 
A 
F
A 
B
F | Fig. 9 | Fig. 10 |
|
F 
H 
Fig. 11
H
10