Delta 36-865 instruction manual

9.Insert the end of the overarm assembly (B) Fig. 18 into the clamp assembly (M) until the gear inside the clamp assembly meshes with the rack on the overarm. Turn the T-handle screw (S) counter-rclockwise until the clamp assembly (M) is securely positioned on the overarm assembly (B).

IMPORTANT: Depending on the application, the overarm assembly (B) can be inserted into either end of the clamp assembly (M).

10.Position three lockwashers and M10 hex nuts (T) Fig. 19, on the three screws, one of which is shown at (L). Tighten all of the overarm clamp-mounting hardware.

11.Align the threaded hole in the swivel joint (V) Fig. 20 with the threaded bolt (W). Attach the swivel joint to the over- arm clamp assembly (M) by turning the lever (X) clockwise. Fig. 21 illustrates the swivel joint (V) attached to the overarm clamp assembly (M). Attach the base (Y) Fig. 22 to the swivel joint (V) in the same manner. Snug-up the locking handle (Z).

12.Fig. 23 illustrates the Versa-FeederTMattached to the overarm assembly.

B

F

M

L

S

Fig. 18

XW

M

V

Fig. 20

Z

V

L

T

Fig. 19

M

V

Fig. 21

Y

Fig. 22

Fig. 23

12