Delta 36-865 instruction manual

Page 11

5.Insert the metal shaft (J) Fig. 12 through the hole in the side of the sleeve (G) and into the wide slots of the pivot cover (H) Fig. 12. Thread the T-handle screw (K) Fig. 13 into the hole of the shaft (J), just enough to hold the pivot pin assembly in position.

6.Fig. 14 illustrates the pivot ball and overarm attached to the stock feeder.

7.Loosely thread three M10 x 50MM hex head screws (L) Fig. 15 into the holes in the overarm clamp assembly (M).

8.Insert an M8 hex nut (P) Fig. 16 into the hex recess of the overarm clamp assembly (M). Loosely thread the lever

(R) with a flat washer into the clamp assembly (Fig. 17).

G

J

Fig. 12

H

J

K

Fig. 13

M

L

Fig. 14

Fig. 15

M

R

P

Fig. 16

Fig. 17

11

Image 11

Contents VERSA-FEEDERTM Important Safety Instructions Table of ContentsCalifornia Proposition Safety Guidelines DefinitionsImportant Safety Instructions General Safety RulesRefer to them often and use them to instruct others Additional Specific Safety RulesGrounding Instructions Power ConnectionsMotor Specifications Functional Description Carton ContentsPage Assembly Time Estimate AssemblyAssembly Tools Required Page Page Page Alternate Assembly Arrangement Page Operation Motor Control SwitchDust Chute Adjusting Feed RatesChanging the Direction of Feed Replacing Feed Rollers Using the Stock Feeder on a Table SAWUsing the Stock Feeder on a Jointer Brush Inspection and Replacement Troubleshooting MaintenanceUsing the Stock Feeder on a Shaper Warranty ServiceAccessories Canadian PORTER-CABLE Delta Service Centers