Chicago Electric 97717 operating instructions Figure B, Should be worn when using

install a 120 volt, 20 Amp, 3-hole, grounded electrical outlet. (See

Figure B.)

FIGURE B

OPERATING INSTRUCTIONS

Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.

3.Secure loose workpieces using a vise or clamps (not included) to prevent movement while working. The work- pieces should be held together firmly while welding. The distance (if any) between the two workpieces must be controlled properly to allow the weld to hold both sides securely while allowing the weld to penetrate fully into the joint.

4.There must not be hazardous objects, such as utility lines or foreign objects, nearby that will present a hazard while working.

5.A barrier, such as a welding curtain or welding shroud should be put up to protect others in the work area and limit the spray of sparks.

					General Operating Instructions
	WARNING		serious		Danger must be worn when
			To prevent			Protective gear
	injury from accidental
					using the Arc Welder; ANSI-
	operation:				approved, arc shaded, eye
	Turn the switch to its off				protection, a full face shield,
	position before performing				welding gloves and welding
	any inspection, maintenance,				apron, NIOSH-approved
	or cleaning procedures.				respirator, and fire resistant
					work clothes without pockets
	Workpiece and Work Area Set Up				should be worn when using
1. Designate a work area that is clean					this product. Do not look at
					the ignited arc without eye
	and well-lit. The work area must not
					protection. Light from the arc
	allow access by children or pets to
					can cause permanent damage
	prevent injury and distraction.
					to the eyes. Light from the
2. Route the power cord along a safe					arc can burn the skin. Do not
	route to reach the work area without				breathe arc fumes.
	creating a tripping hazard or exposing			1.	The duty cycle defines the number of
	the power cord to possible damage.				minutes, within a 10 minute period,
	The power cord must reach the work
					during which a given Welder can
	area with enough extra length to allow
					safely produce a particular welding
	free movement while working.
					current. For example, at a 10% duty
SKU 97717		For technical questions, please call 1-800-444-3353.					Page 10