Specifications
Electrical | 120 V~ / 60 Hz | |
Requirements | Power Plug: 20 Amp/3 Prong / Grounded | |
Input Current | 20 Amps | |
|
| |
Power Switch | Rocker with Light (Yellow) | |
Type | ||
| ||
Indicators | Thermal Overload Light (Red) | |
|
| |
Settings | Minimum: 50 Amp | |
Maximum: 70 Amp | ||
| ||
Welding | Up to 1/8” Thick Steel in a Single Pass | |
Capacity | ||
| ||
Recommended | 1/16” Diameter for 15 Amp Circuits | |
Electrode Size | Up to 5/64” Diameter for 20 Amp Circuits | |
Duty Cycle | 10% @ 70 Amps / 20% @ 50 Amps | |
|
| |
| Welding Shield (Qty. 1) | |
Accessories | Hammer/Brush (Qty. 1) | |
Electrode Holder (Qty. 1) | ||
| ||
| Ground Clamp (Qty. 1) |
Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as pos- sible.
WARNING To prevent serious
injury from accidental operation:
Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its electrical outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Assembly
1.To assemble the Welding Shield, place the Shield on a flat surface.
Press the Handle into place. Then insert the Filter Lens.
(See Figure A.)
Initial Set Up
Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
FIGURE A
2. This Arc Welder is equipped with a
120 volt, 20 Amp,
SKU 97717 | For technical questions, please call | Page 9 |