VIII. Filter Assembly

Before attaching filter, you must first carefully pull foam silencer on to end of plenum, pushing black plastic end against flange plate. It is a tight fit.

External 39” Filter Assembly

*Silencer Included.

1.Attach cartridge with hardware provided making sure gasket is attached. See Fig. 1

2.If Filter requires additional support. Use the plate at the top of the filter to support the filter assembly.

Note: If filter cartridge is located away from the cyclone and motor, additional square-to-round connectors and pipe can be purchased.

The

GORILLA

Silencer

Filter

Fig. 1		Gasket
		Material
(4)	3/8” x 1” Bolts
(8)	Washers
(4)	Serrated Nuts

For Filter cleaning instructions and

Dust Pan clipping instructions, see pg. 11.

Rod

Brace

Washer

Wing Nut

Dust Bin

Dust Pan Clips (3)

No Filter Assembly

1.Exhaust air to exterior of building. Mount directly at the hole in exterior wall or use a square-to-round transition and ductwork to vent air to exterior.

Option -

* Exhaust Diverter - Can be used either up or down

* Only usable on No Filter.

The

GORILLA

Note: Do not return exhaust air to the shop unless filter media is added.

Caution:

If exhaust air is vented outside you must provide make up / return air.

Flue gases (carbon monoxide) can be drawn into the shop from furnaces, water heaters or other appliances.

Caution: Rotating blades! Keep hands clear. Keep people away from exhaust.

2HP Super Dust Gorilla Owner’s Manual c O.A.S. 2007