Grizzly G5954 Set Up, Small Component Inventory Figure Qty, Other Components and Hardware Qty

SECTION 3: SET UP

Inventory

After all the parts have been removed from the two boxes, you should have the following items:

Large Component Inventory (Figure 2)		Qty
A.	Casters (shown attached to base plate)	.... 4
B.	Base Plate	1
C.	Motor/Fan Assembly	1
D.	Stand Legs	4
E.	Collector	1
Small Component Inventory (Figure 3)		Qty
F.	Gasket	1
G.	4-in-1 Inlet Adapter and Inlet Caps	1
H.	Upper Bag Support Extenders	2
I.	Lower Support	1
J.	Upper Bag Supports	2

C D E

B A

Figure 2. G5954 Large Component Inventory.

I

K.	Plastic Elbows 4" 90º	2
L.	Lower Bags	2
M.	Upper Bags	2

H

J

Other Components and Hardware		Qty
• Flange Bolts 3⁄8-16 x 1⁄2" (A, B, C, D)		........ 32
•	Washers 3⁄8" (D, E)	16
• Hex Nuts 3⁄8-16 (C, E, F)		8
• Hex Bolts 3⁄8-16 x 11⁄4" C, E, F)		8
• Flange Bolts 5⁄16-18 x 3⁄4" (I, J)		6
• Hex Nut 5⁄8-11 (I)		1
• Flange Bolts 1⁄4-20 x 1⁄2" (H, J)		4
• Lower Support Foot Pad 5⁄8-11		1
•	Open-End Wrench 10/12mm	1
•	Bag Clamps	4

NOTICE

Some hardware/fasteners on the inventory list may arrive pre-installed on the machine. Check these locations before assuming that any items from the inventory list are miss- ing.

-10-

K

G L

F

M

Figure 3. G5954 Small Component Inventory.

In the event that any nonproprietary parts are missing (e.g. a nut or a washer), we would be glad to replace them, or for the sake of expedi- ency, replacements can be obtained at your local hardware store.

G5954 5HP Dust Collector