Grizzly G5954 owner manual Collection Bags, To set up the collecton bags

3.Press-fit the 4-in-1 inlet adapter onto the col- lector inlet, as shown in Figure 8.

Figure 8. Installing 4-in-1 inlet adapter.

Collection Bags
Components and Hardware Needed:	Qty
Upper Bag Supports	2
Upper Bag Support Extenders	2
Lower Support	1
Lower Support Foot Pad	1
Upper Collection Bags	2
Lower Collection Bags	2
Flange Bolts 5⁄16-18 x 3⁄4	6
Flange Bolts 1⁄4-20 x 1⁄2	4
To set up the collecton bags:

1.Screw the lower support foot pad onto the bottom of the lower support.

2.Attach the lower support to the Collector using two 5⁄16-18 x 3⁄4 hex bolts.

G5954 5HP Dust Collector

3.Attach each upper bag support to an upper bag support extender using the 1⁄4-20 x 1⁄2 hex bolts.

4.Attach each upper bag support to the Collector using two 5⁄16-18 x 3⁄4 hex bolts.

5.Hang an upper bag from an upper bag sup- port extender.

6.Pull the bottom of the upper bag over the lip of the collector below it, and fasten it in place with a bag clamp, as shown in Figure 9.

Figure 9. Fitting bag onto collector.

7.Repeat Steps 4 & 5 for the other upper bag.

8.Fit a lower bag over the bottom lip of the collector, and fasten it in place with a bag clamp.

9.Repeat Step 6 for the other lower bag.

-13-