Grizzly G0710 owner manual Test Run, To test run the machine

Page 18

Test Run

Do NOT put hands or small objects near inlet openings during opera- tion. Objects sucked into the inlet will hit the impeller blade. Failure to heed this warning could result in personal injury or property damage.

Once the assembly is complete, test run your machine to make sure it runs properly and is ready for regular operation.

The test run consists of verifying the following:

1)The motor powers up and runs correctly, and

2)the safety disabling mechanism on the switch works correctly.

If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review Troubleshooting on Page 21.

If you still cannot remedy a problem, contact our Tech Support at (570) 546-9663 for assistance.

To test run the machine:

1.Make sure you have read the safety instruc- tions at the beginning of the manual and that the machine is setup properly.

2.Make sure all tools and objects used during set up are cleared away from the machine.

3.Connect the machine to the power source.

-16-

4.Verify that the machine is operating correctly by turning the machine ON.

—When operating correctly, the machine runs smoothly with little or no vibration or rubbing noises.

—Investigate and correct strange or unusual noises or vibrations before operating the machine further. Always disconnect the machine from power when investigating or correcting potential problems.

5.Turn the machine OFF.

6.Remove the switch disabling key, as shown in Figure 12.

Figure 12. Removing switch key from paddle

switch.

7.Try to start the machine with the paddle switch.

—If the machine does not start, the switch disabling feature is working as designed.

—If the machine starts, immediately stop the machine. The switch disabling feature is not working correctly. This safety feature must work properly before proceeding with regular operations. Call Tech Support for help.

Model G0710 Dust Collector (Mfg. since 6/10+)

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Model G0710 1HP Wall Hanging Dust Collector Page Table of Contents Contact Info IntroductionManual Accuracy Machine DescriptionMACHINe dATA SHeeT Impeller Information Safety Safety Instructions for MachineryUnattended OPERATION. Never­ leave­ Additional Safety Instructions for Dust Collectors Full-Load Current Rating Power SupplyAvailability Circuit InformationMinimum Gauge Size 12 AWG Grounding RequirementsExtension Cords 50 ftUnpacking SetupNeeded for Setup InventoryHardware Recognition Chart Site Considerations Assembly To assemble and mount the dust collectorCollection System Material SelectionDuct Grounding Dust Collection Machine ApproximateMachine Average Dust Port Size Test Run To test run the machineOperations GeneralH7215-4 x 5 Rigid Metal Flex Hose G6163-4 Metal Hose Clamp AccessoriesG3181-Dust Collection Kit #1 H4340-0.3 Micron BagH2797-110V Shop Fox Remote Control G0572-Hanging Air Filter With RemoteH6396-Small Downdraft Table H6397-Large Downdraft Table Schedule MaintenanceBag Cleaning LubricationService TroubleshootingMotor & Electrical Dust Collector Operation To Collection System beginning on Page 14 forWiring Wiring Safety InstructionsPaddle Switch 110V Motor220V Motor Parts MainMachine Labels Warranty Card CommentsGrizzly INDUSTRIAL, INC BOX BELLINGHAM, WAWarranty and Returns Warranty and ReturnsOrder Hours a DAY
Top Page Image Contents