Filter Bag Kit Assembly

If you purchased a DC-1100BK, or DC-1100MK Dust Collector, this section describes the assembly and installation of the contents of the Filter Bag Kit (SN 708636F or 708636MF).

Filter Bag Installation

Referring to Figure 7:

1.Place the hanger (A) on the hanger bracket (B).

2.Slide the filter bag loop (C) over the hanger hook.

3.Feed the retainer strap (D) through the loops on the filter bag (E) and fasten to the collector housing (F).

Collector Bag Installation (30 Micron Kit)

Referring to Figure 8:

4.Insert the ring of the collector bag (A) at an angle into the housing (B) through the opening at the bottom. Pull down on the bag to make sure it “seats” in the housing.

5.Position the plastic window in front so that you can easily see when the collector bag is full.

Collector Bag Installation (5 Micron Kit)

The 5-Micron Filter Bag Kit includes clear plastic collector bags. Refer to Figures 11 and 12 on the next page, along with the accompanying instructions, to install these.

After completing the filter bag and collector bag installation, proceed to Electrical Connections.

Figure 7

Figure 8