Craftsman 152.213361 operating instructions SiDE Support Assembly, Swivel Caster to Base Assembly

2,

3,

DO NOT assembb the Dust Colbctor until you are sure the tool IS NOT plugged in,

DO NOT assembb the Dust Colbctor until you are sure the power switch is in the "OFF" position,

For your own safety, DO NOT connect the machine to the power source until the machine is completely assembled and you read and understand the entire Owner's Manual,

SiDE SUPPORT ASSEMBLY

MAKE CERTAIN THE DUST COLLECTOR IS DISCONNECTED FROM THE POWER SOURCE.

Fig. 6

SWIVEL CASTER TO

BASE ASSEMBLY

MAKE CERTAIN THE DUST COLLECTOR IS DISCONNECTED FROM THE POWER SOURCE.

Fig. 5

1,

2,

A

3,

B

4,

C

Place the base (A) in an upright position, See figure 6,

Align two hobs in the wider end of side support (B) with two hobs (C) in the base, See figure 6,

insert a 5/16-18 x 5/8" hex head screw through each of the two hobs in the side support and base,

Place a 5/16-18 flange hex nut onto each screw and tighten securely,

2,

3,

insert bolt from swivel caster through one of the four hobs (A) in the base (B), three are not shown, See figure 5,

Place 3/8-16 flange hex nut onto bolt of swivel caster and tighten,

Repeat Steps 1,2 and 3 for the remaining three swivel caster assemblies,

Fig. 7

5, Repeat Steps 1, 2, 3, and 4 to assemble the second side support, See figure 7,

10