DeWalt 50-665 instruction manual Locking Switch in the OFF Position, To R Maintenance

Page 11

A

B

Fig. 23

LOCKING SWITCH IN THE OFF POSITION

W e suggest when the dust collector is not in use that the ON/OFF switch be locked in the OFF position. This can be done by grasping the switch toggle (B) Fig. 23, and pulling it out of the switch (A) as shown. W ith the switch toggle (B) removed, the switch will not operate. However, should the switch toggle (B) Fig. 23, be removed while the machine is running, it can be turned OFF, but cannot be restarted without inserting the switch toggle (B) back into the switch.

Fig. 24

MAINTENANCE

NOTE: M A K E CERTAIN THE MACHINE IS DISCONNECTED F R O M THE P O W E R SOURCE.

The dust bag furnished with the dust collector features a zippered opening for fast and easy dust removal, as shown in Fig. 24. IMPORTANT:The operator performing this cleaning function should always wear eye protective goggles. The aluminum blower impeller and all sheet metal fittings are maintenance-free and should not require any maintenance during the life of the unit.

M O TO R MAINTENANCE

Removing dust and dirt: Blow off the motor with low pressure air to remove dust or dirt. Air pressure above 50 P.S.I. should not be used as high pressure may damage insulation. IMPORTANT:The operator performing this cleaning function should always wear eye protective goggles. Dust can cause excessive insulation temperatures.

11

Image 11
Contents 11/2 H.P. Dust Collector Shown with Accessory Dust Collector DrumTable of Contents Safer at the rate for which it was designed Important Safety RulesKeep Guards in Place and in working order O N O T handle the plug or dust collector with wet hands Importa N T Safety Rules F O R Dust Collecto R SAV E These Instructions Introduction Reducer Inlet Elbows Gasket Material Gaskets PackingJ Fig AssemblyAs shown in Fig Page Assemble reducer B , over the end of inlet elbow H Insert the bag clamp Z , through the loopsof the dust bag aON/OFF Switch Connecting Dust Collector to Power SourceTo R Maintenance Locking Switch in the OFF PositionMaintenance Two Year Limited Warranty