DeWalt 50-665 instruction manual Assembly, J Fig

Page 6

ASSEMBLY

1.Place gasket (A) Fig. 3, on bottom of motor and blower assembly (B). Align four holes in gasket with holes in motor and blower assembly and assemble cover

(C) Fig. 3, to gasket and motor and blower assembly with four hex head screws, flat washers, lockwashers, and locknuts (D).

2.Fig. 4, illustrates the cover (C) assembled to the underside of motor and blower assembly (B).

3.Peel the adhesive paper (E) Fig. 5, from the back of the gasket material (F) and press the gasket material around the underside of the dust collector cover (C). Cut off any excess gasket material.

4.Carefully turn the assembly over. Place gasket (G) Fig. 6, over two holes in cover (C) and secure upper inlet

elbow (H) to cover with two 3/8-16 x 1-1/4 hex head screws and flat washers (J), as shown in Fig. 7.

C

F

E

Fig. 5

B

C A

D

Fig. 3

C

B

Fig. 4

C

G

H

JJ J Fig. 6

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Shown with Accessory Dust Collector Drum 11/2 H.P. Dust CollectorTable of Contents Important Safety Rules Keep Guards in Place and in working orderSafer at the rate for which it was designed Importa N T Safety Rules F O R Dust Collecto R S AV E These Instructions IntroductionO N O T handle the plug or dust collector with wet hands Packing Reducer Inlet Elbows Gasket Material GasketsAssembly J FigAs shown in Fig Page Insert the bag clamp Z , through the loopsof the dust bag a Assemble reducer B , over the end of inlet elbow HConnecting Dust Collector to Power Source ON/OFF SwitchLocking Switch in the OFF Position MaintenanceTo R Maintenance Two Year Limited Warranty
Top Page Image Contents