DeWalt 50-665 instruction manual As shown in Fig

Page 7

5.Position the remaining inlet elbow (K) Fig. 8, at the underside of dust collector lid (C) as shown. Align the mounting holes in inlet elbows (K) Fig. 8, with screws (J) assembled to upper inlet elbow (H) shown in Fig. 7, STEP 4, and fasten the upper and lower inlet elbows to the cover with remaining two flat washers, lockwashers, and locknuts(J) Figs. 7 and 8.

6.Place the sheet metal cylinder (L) Fig. 9, onto the underside of the cover.Align four holes in cylinder brack- et, three of which are shown at (M), with four holes (N) in the underside of cover and fasten with four 1/4-20 x 5/8 hex head screws, lockwashers, and locknuts (P) Fig. 10. NOTE: Assemble screws from the top of the lid down- ward. CAUTION: Sheet metal cylinder (L) is extremely sharp; use protective gloves when assembling the sheet metal to the underside of the lid.

7.Assemble safety grid (V) Fig. 11, over metal cylinder

(L) and fasten grid to cylinder with three pan head screws

(W) as shown in Fig. 12.

P

L

P

Fig. 10

J

Fig. 7

H

C

J

K

Fig. 8

N

L

M

M N

Fig. 9

V

L

Fig. 11

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents 11/2 H.P. Dust Collector Shown with Accessory Dust Collector DrumTable of Contents Keep Guards in Place and in working order Important Safety RulesSafer at the rate for which it was designed AV E These Instructions Introduction Importa N T Safety Rules F O R Dust Collecto R SO N O T handle the plug or dust collector with wet hands Reducer Inlet Elbows Gasket Material Gaskets PackingJ Fig AssemblyAs shown in Fig Page Assemble reducer B , over the end of inlet elbow H Insert the bag clamp Z , through the loopsof the dust bag aON/OFF Switch Connecting Dust Collector to Power SourceMaintenance Locking Switch in the OFF PositionTo R Maintenance Two Year Limited Warranty
Top Page Image Contents