ASSEMBLING FILTER
A N D DUST COLLECTION B A G S TO D R U M
1.Thread 5/16 hex locknut (A) Fig. 10, onto the end of bag support rod (B). Place lockwasher and flat wash- er (C) Fig. 10, onto bag support rod (B). Thread rod into hole (D) and tighten locknut (A) against motor and blower assembly (E) to hold support rod (B) upright. Height of support rod can be adjusted afterthefilterbagisinplace.
2.Hook the loop on the top of filter bag (F) Fig. 11, onto the end of support rod (B).
3.Position open end of filter bag (F) Fig. 11, over the lip of drum (G). NOTE: It may be necessary to adjust the height of the drum support rod at this time. If adjustment is necessary, loosen locknut (A) Fig. 11, and rotate support rod (B) as needed to obtain proper rod height to support filter bag (F). Tighten locknut (A) Fig. 11. Insert locking band (H) through the hem of filter bag (F) and fasten filter bag to drum by locking clamp (J) as shown in Fig. 12. IMPORTANT:Make certain band (H) is positioned in the channel of drum (G) before locking clamp (J).
4.Insert remaining locking band (H) Fig. 13, through hem of dust collection bag (K). Position open end of bag over the lip of drum (G) and fasten with locking clamp (J). NOTE: Make certain locking band (H) is positioned in the channel of drum before locking clamp (J).
E
A 
B
DC
Fig. 10
B
F
H
G
A
Fig. 11
H
J
G
Fig. 12
G 
JH
K 
Fig. 13
8