TO FILL THE GREASE GUN, USING A FILLER PUMP
1.Pull back on the Follower Handle (19) until the Follower Rod (22) is fully ex- tended. Then, turn the Follower Handle (19) and latch the Follower Rod into the slot on the end cap of the Grease Tube (2). (See Figure B.)
2.Attach the connector of the filler pump (not included) to the Filler Valve (12) on the Grease Gun. (See Figure B.)
3.Operate the filler pump to fill the Grease Tube (2). CAUTION! Make sure to read and understand all safety warnings and instructions as outlined in the owner’s manual of the filler pump.
4.When the Follower Rod (22) automatically extends out from the rear of the Grease Tube (2) about 8 inches, the Grease Tube is filled. Then, release the Follower Key (20) from the slot on the end cap of the Grease Tube (2) to allow the Follower Rod (22) to move forward into the Grease Tube. (See Figure B.)
TO ATTACH THE BATTERY PACK TO THE GREASE GUN
1.Make sure the Switch (18) is in its “OFF” position.(See Figure C.)
2.Depress the Lock Button on each side of the Battery Pack (3), and insert the Battery Pack firmly into the bottom of the Right/Left Covers (1, 5) of the Grease Gun. Then release pressure on the Lock Buttons, and check to make sure the Battery Pack is locked in place. (See Figure C.)
SWITCH
(18)
RIGHT/LEFT COVERS
(1, 5)
LOCK BUTTON
BATTERY PACK
(3)
FIGURE C
SKU 92196 | For technical questions, please call | PAGE 9 |