Chicago Electric 67256 operating instructions Figure D

Page 9

be mounted at angles up to 90° left or right.

Angled Cutter Blade (501)

Figure D

Note: The long Angled Cutter Blade (501) should only be used in the straight ahead position. (See Figure D.)

Figure E

Place Large

Washer,

 

cupped side

 

down

Torque to 10 ft-lbs

Figure F

4.Tighten the cap screw onto the Spindle using the provided hex key.

Torque firmly (approximately 10 ft-lbs). After securing, the attachment should not move on the spindle. If it can move with the power off, remount it, making sure that the holes on the attachment line up with the pins on the spindle. Tighten the cap screw securely.

3.Slide the Small Washer (2), then the

Large Washer (3) onto the the Cap

Screw (1). Make sure the cupped side of the Large Washer is toward the tool. While holding the attachment over the pins on the tool, thread the Cap Screw in place. (See Figure E.)

REV 10e

SKU 67256

For technical questions, please call 1-800-444-3353.

Page 9

Image 9
Contents For technical questions or replacement parts, please call MULTI-FUNCTION Power ToolGeneral Safety Warnings Save This ManualFor technical questions, please call Gfci reduces the risk of electric shock Specific Safety Warnings Vibration Safety Double Insulated Tools Tools With Two Prong Plugs GroundingExtension Cords See Outlets for 2-Prong PlugSpecifications UnpackingSee Table a Assembly Instructions ComponentsSee Figure B Figure D Work Piece and Work Area Set Up Operating InstructionsGeneral Operating Instructions It must be replaced only by a qualified service technician Maintenance ServicingPlease Read Following Carefully SKU For technical questions, please callProblem Possible Causes Likely Solutions TroubleshootingPart Description Qty Parts List and Assembly diagramRecord Product’s Serial Number Here Limited 90 DAY Warranty