Grizzly T26416 owner manual Compressed Air System

Page 10

Compressed Air

System

The Model T26416 is designed to be oper- ated at 70-120 Psi using clean, dry, regu- lated, compressed air. Do not exceed the 120 PSI maximum operating pres- sure for your model.

Before using your new stapler, regulate the air pressure on your air compressor to the minimum Psi for your model.

An in-line filter/lubricator/regulator unit, depicted in Figure 5, can be installed and should be located as close to the stapler as possible.

Quick	Quick	Lubricator
Connector	Connector		Regulator
Your			Air
Tool			Compressor
Quick
Coupler		Quick
	Air Hose	Quick	Filter
	Air Hose	Coupler
		Coupler

Figure 5. Installed filter lubricator

regulator.

This filter/lubricator/regulator unit will protect your tool from damaging water build-up, allow you to adjust and maintain constant air pressure to your tool, and save you the inconvenience of having to manually lubricate your tool every time you use it.

Check the current Grizzly catalog for avail- ability of this unit. If you plan on install- ing a filter/lubricator/regulator unit in your compressed air system, always follow the connection instructions that come with the unit.

-8-	Model T26416 Crown Stapler

Image 10

Contents Model T26416 Page Table of Contents Before Operating This Equipment SafetySafety Instructions For Pneumatic Tools Mation about proper operation of the equipmentSafety Instructions for Pneumatic Tools Additional Safety for Staplers Introduction SpecificationsForeword Contact Info SET UP UnpackingInventoryAir Deflection Loading StaplesTo load the stapler Compressed Air System Test Run To test run staplerOperations To perform a typical operationAccessories Safety glassesMaintenance CleaningLubricatingTo replace piston assembly ServiceReplacing O-Rings Piston Assemblies Troubleshooting Symptom Possible Cause SolutionParts To reduce risk of injuryParts List DescriptionWArranty