Grizzly T26416 owner manual Troubleshooting, Symptom Possible Cause Solution

Troubleshooting

Symptom	Possible Cause		Solution
Air leaking at trig-	1.	O-rings in trigger valve housing	1.	O-rings must be replaced
ger valve area.		are damaged.		& operation of safety probe
				must be checked.
Air leaking	1.	Loose screws in housing.	1.	Tighten screws.
between housing	2.	Damaged O-ring.	2.	Replace O-ring.
and hose.	3.	Loose air fitting.	3.	Tighten air fitting & use tef-
				lon tape.
Air leaking	1.	Damaged seal.	1.	Replace damaged seals.
between housing
and cap assembly.
Tool skips staples	1.	Air leaks.	1.	Tighten screws and fittings.
while discharging.	2.	Dirt in nose.	2.	Clean nose.
	3.	Dirt or damage prevents sta-	3.	Clean	magazine	and
		ples from moving freely in mag-		inspect/repair damage.
		azine.
	4.	Inadequate air flow to tool.	4.	Check fitting, hose, com-
				pressor & air pressure.
	5.	Worn O-ring on piston or lack	5. replace		piston	O-ring.
		of lubrication.		Lubricate.
	6. damaged O-rings on trigger		6. replace		trigger	valve
		valve.		O-rings.
	7.	Cap seal leaking.	7.	Replace cap seal.
Tool runs slowly	1.	Stapler is not sufficiently lubri-	1.	Lubricate stapler.
or has a loss of		cated.
power.	2.	Broken spring in cap assem-	2.	Replace spring.
		bly.
	3.	Exhaust port in cap is blocked.	3.	Clean or replace damaged
				internal parts.
Fasteners frequent-	1. Staples are the wrong size.		1.	Use correct staples.
ly jam the stapler.	2.	Staples are bent or dirty.	2.	Use undamaged, clean sta-
				ples.
	3.	Magazine or nose screws are	3.	Tighten magazine.
		loose.
	4.	Driver or driver guide are worn	4.	Replace worn or damaged
		or damaged.		parts.

-14- Model T26416 Crown Stapler